Multi Band-Its

Multi functional tool. Linear action – provides very smooth finish. Work large areas of sheet stainless steel, aluminium, and composites. Easy to fit options to enable finishing of pipes and tubes. Variable speed control.

Performance figures for the multi band-it

Multi Band-it models	RPM range - light load	Voltage	Power	Belt surface speed (meters per second)	Sound level 1.5 meters from Band-it	Hand-arm vibration level in m/s² r.m.s. frequency-weighed vibration in the worst axis.
MB924	1,500 to 4,000	240V, 50/60Hz	900W	22.0	77 dB	2.5
MB911	1,500 to 4,000	110V, 50/60Hz	900W	22.0	77 dB	2.5

Note 1: All performance figures are average readings, taken by Seco Engineering Co Ltd. under working conditions on a steel plate, with light load as wheel should not be run free.

Note 2: Sound level readings were taken be Seco engineering Co. Ltd, under working conditions grinding a block of steel using abrasive bands.

Note 3: The same motors are used on both the standard and dust collecting Band-its. To obtain the performance figures, the motors are assembled onto either the standard or the VA shrouds.

Note 4: These electric Band-its have been individually tested for vibration. See EC Declaration of Conformity for the reading.

Note 5: Vibration levels have been measured under working conditions by grinding a block of steel using an inflatable rubber tyre and 90 x 395mm, 240 grit aluminium oxide belts. Checked by Seco Engineering Co. Ltd