ML - Performance Figures and Specialist Arms

ML

ML -VA (Vacuum Assisted - Dust Collecting)

 

Beltit Arms For Polishing Pipes

50202POL - operating 25mm wide by 610mm long belts.

50203POL - operating 25mm wide by 760mm long belts.

Arms to be used on any category C Beltits (pneumatic + electric)

Polishing arms enable the abrasive, felt, finishing belt to "wrap around" a pipe/ tube. For very fine finishing work, ensure that the belt, when it runs over the wheel, does not touch the pipe/tube.

Performance Figures for the Medium Light Beltit and its Dust Collecting (VA) Version

Beltit	RPM @ 90 PSI (6.12 bar) no load	Air consumption Ltrs. per minute for max. performance and continuous running	Belt surface speed, metres per second	Sound levels at 90 PSI (6.12 bar) 1.5 metres from Beltit Leq dB (A)	Hand-arm vibration level in ms2 r.m.s. frequency- weighted vibration in the worst axis
ML	14,800	708 (25 CFM)	26.7	77.3	Less thsn 2.5
MLVA	13,700	678 (24 CFM)	24.7	74.3	Less thsn 2.5

Note 1: All performance figures are average readings.

Note 2: Sound level readings were taken without abrasive belts as the wide range of abrasive grits and backings have varying effect on the readings.

Note 3: Vibration levels measured under working conditions grinding a block of steel, using an abrasive belt 19 x 533mm Aluminium Oxide, P80 at 90PSI (6.12 bar).

Note 4: Sound and vibration levels certified by the Institute of Sound and Vibration Research at the University of Southamption in the UK.