Beltit E240A and E110A - Performance Figures and Specialist Arms

E240A and E240A-VA
E110A and E110A- VA

E240A-VA & E110A-VA
(Vacuum Assisted - Dust Collecting)

Beltit Arms For Polishing Pipes

50202POL - operating 25mm wide by 610mm long belts.

50203POL - operating 25mm wide by 760mm long belts.

Arms to be used on any category C Beltits (pneumatic + electric)

Polishing arms enable the abrasive, felt, finishing belt to "wrap around" a pipe/ tube. For very fine finishing work, ensure that the belt, when it runs over the wheel, does not touch the pipe/tube.

Performance figures for the Electric Standard Duty Beltit and its dust collecting (VA) version

Beltit	RPM no load	Voltage	Power	Belt surface speed, (metres per second)	Sound levels 1.5 metres from Beltit	Hand-arm vibration level in ms2 r.m.s. frequency- weighted vibration in the worst axis
E240A	9,600	240 V AC	1,100 W	17.9	78 Leq Db(A)	Less than 2.5
E240AVA		50 Hz
E110A	9,600	110 V AC	1,100 W	17.9	78 Leq Db(A)	Less than 2.5
E110AVA		50 Hz

Note 1: All performance figures are average readings.

Note 2: Sound level readings were taken without abrasive belts as the wide range of abrasive grits and backings have varying effect on the readings.

Note 3: Vibration levels measured under working conditions grinding a block of steel, using an abrasive belt 19 x 533mm Aluminium Oxide, P80 at 90PSI (6.12 bar).

Note 4: Sound and vibration levels certified by the Institute of Sound and Vibration Research at the University of Southamption in the UK.